North Sails NEWS
Story Contributors: Mike Ingham
THISTLE HEAVY AIR TIPS
A Recap From the Midwinters East with Mike Ingham
Breeze on! The 2020 Thistle Midwinters East was sailed in overpowered conditions for the entire weekend. It was a lot of fun! Going fast was about hiking hard, steering for waves, playing the main to keep the boat flat, and good on board communication.
Here are Mike’s top 5 points on sailing fast in a breeze:
- Flat defined: I define this as a few degrees of heel (not necessarily totally zero degrees flat)
- Helm check: You should have no noticeable helm, and to check this you should let go of the tiller and see how fast you head up. You will likely find that at 0 degrees you go straight, and with a few degrees you head up slowly. If you head up at all quickly, you are too heeled!
- Hard hike defined: 100% hike is unsustainable. 80% or something like that is a sustainable hike for long races on multiple race days.
- Pain: 80% still hurts! There is no way around it, hiking hard is work.
- Your 80%: Everyone’s 80% is different, all you can do is what you can do. Find your 80% and stick with it.
- Hike steady: Don’t hike harder in a puff and softer in a lull (assuming the lull is still overpowered as most were at MWE). Sustain that 80%.
- DO hike harder in critical situations. Occasionally I would say something like “100% hike until we cross this pack”.
- DO hike less when not critical. “50% hike, there is a gap ahead and behind, lets save our energy to the finish”
Vang is a Big Depower Tool
- Vang flattens the sail: It bends the mast down low by ‘ramming’ the boom forward into the mast. You will notice more overbend wrinkles when vang is on, less when it is off. More wrinkles means your sail is flatter, less means it is fuller.
- Ease in lulls: If you do need power in a lull, ease the vang and sheet in. Still at 80% hike until you are clearly underpowered.
- Pull on vang in breeze: If you need to depower more, tighten your vang. There is a limit; our boom bends a lot with vang on full. Our limit is just before we feel we will break the boom.
Main and Steering
- Keep the boat flat: To state the obvious, easing the main and steering up keeps the boat flat in a puff, and vise-versa in a lull.
- It takes both: It is always a combo of the main and steering, I know of no condition where I do one without the other, its the % of each changes depending on the wave condition
Main and Steering in Waves and Wind
- Foot: In waves, pinching up can be super slow because the boat is slowed by waves.
- Aggressive steering: I steer all over the place looking for the best path through waves. I find low spots and avoid steep waves, or in smoother waves to steer up the face and down the back.
- Steer to waves, trim to heel: To do this, I have to prioritize steering where I need to for the wave while trimming the main to keep the boat flat
Main and steering in flat water:
- OK to pinch: In flat water, I can steer wherever I want with no worry that I will slam into a wave
- Pinch to depower: In flat water when I am overpowered, I prioritize trying to steer to the wind (up in a puff, down in a lull)
- Mainsheet to fine tune: I will still need small main changes to keep the boat flat where I can’t keep up with it steering
It’s Rarely All Waves or All Flat
Most of the time, there is some combo of steering for wind and steering for waves. In the flattest water, 100% of my steering is to the wind because there are no waves. In the roughest water, I probably steer to the waves 80%, and steer to the wind 20%. I would say a typical thistle heavy wind race at MWE was 50% / 50%. The bigger waves I would have to steer through, but flat spots would allow me to steer up in a puff
ALWAYS play the main
- Waves: In waves, I am steering a lot through waves, so I need to play the main constantly and aggressively. I go through a large (at times an armlength) range.
- Flat: In flat water, even though I want to steer mostly to keep the boat flat, I find I need to constantly adjust the mainsheet to keep the heel just right. These are small (a few clicks here and there) but frequent adjustments
When we are overpowered, we set the jib to the main backwind bubble. That means when the main is eased a lot, we have to let the jib out too. If our main flogs the jib is to blame (until it blows about 30, then there is nothing left to do but flog both sails!) A gentle bubble of about 1 foot behind the mast is about right. More and you need to ease. Less and you need to trim.
Stay ahead of the curve by calling wind and waves
- “Puff in 3, 2, 1 puff on” allows me to start easing at “2” and that prevents an initial heel in the puff. Very effective.
- “Big wave”, or even better something descriptive like “Square wave” or “A lot of waves” is super useful.
- “Flat spot” is great info on a bumpy day. If there are lots of waves, it seems silly to call them all, I need to just assume there are waves until told otherwise
That should cover it. Sailing flat by being proactive on depowering (vang…), then sailing the right combo of steering and main sheet is the way to go fast in big breeze. Oh yes, almost forgot – hike hard!